W201EHS420
Secure Checkout
21 Gauge 1-5/8" X 3-1/4" 20' Back-to-Back Channel, Short Slots, S4

Thumbnail Filmstrip of 21 Gauge 1-5/8" X 3-1/4" 20' Back-to-Back Channel, Short Slots, S4 Images

    Purchase 21 Gauge 1-5/8" X 3-1/4" 20' Back-to-Back Channel, Short Slots, S4

    21 Gauge 1-5/8" X 3-1/4" 20' Back-to-Back Channel, Short Slots, S4

    Part Number: W201EHS420
    Discontinued Part Number(s):
    Florida Strut: FS12158EHBBS420
    Versabar: VA1201PLHS420
    Wesanco/ZSI: W201SSST30420
  • Description

    W201EHS420, 12 gauge 1-5/8" X 3-1/4" back-to-back channel with short slots, 20' feet long with 304 Stainless Steel finish.

    • Back-to-Back Strut: 1 5⁄8" (41mm) width x 3 1⁄4" (83mm) height
    • Short Slots: 9⁄16" (14mm) x 1 1⁄8" (29mm) on 2" (51mm) centers
    • Length tolerance plus or minus 1⁄16"
    Technical Specifications

    Additional technical specifications, including 'Allowable Beam Loads', 'Allowable Column Loads', and 'Section Properties' can be found on the W201EH Channel w/Short Slots 12 Gauge Series 1-5/8" x 3-1/4" category page.

    Finish Finish Code Description
    ST304 Stainless Steel: Channel S4 Heat resisting chromium and chromium-nickel stainless steel plate, sheet, strip for pressure vessel.
    Features
    • Channels are manufactured by the cold roll forming process which produces cross sections of uniform dimensions within tolerances established by the Metal Framing Manufacturer's Association, Metal Framing Standards Publication No. MFMA-4.
    • Steel used in the manufacture of channels conforms to the ASTM specifications under the Specifications tab below.
    • Design is based on AISI S100-2016 "Specification for the Design of Cold-Formed Steel Structural Members." Maximum bending stress used in design is 25,000 pounds per square inch (PSI). This is based upon a virgin steel minimum yield stress of 33,000 psi cold worked to an average yield stress of 42,000 psi.
    • Welds meet the performance requirements of section 4 of AISI S100-2016 "Specification for the design of Cold-Formed Steel Structural Members." All multiple sections of two or more single channels are resistance spot-welded approximately 2" to 3" (51mm to 76mm) on center.
    W201EHS420


    For more information go to https://www.p65.warnings.ca.gov