W15OEHGR10
Secure Checkout
12 Gauge 1-5/8" X 3-1/4" 10' Channel, Short Slots, GR

Thumbnail Filmstrip of 12 Gauge 1-5/8" X 3-1/4" 10' Channel, Short Slots, GR Images

    Purchase 12 Gauge 1-5/8" X 3-1/4" 10' Channel, Short Slots, GR

    12 Gauge 1-5/8" X 3-1/4" 10' Channel, Short Slots, GR

    Part Number: W15OEHGR10
    Discontinued Part Number(s):
    Florida Strut: FS12314EHGN10
    Versabar: VA11PLHGR10
    Wesanco/ZSI: W150SSGR10
  • Description

    W15OEHGR10, 12 gauge channel strut with short slots, 10 feet long, with paint green powder coating.

    • Strut: 1 5⁄8" (41mm) width x 3 1⁄4" (83mm) height
    • Short Slots: 9⁄16" (14mm) x 1 1⁄8" (29mm) on 2" (51mm) centers
    • Length tolerance plus or minus 1⁄16"
    Technical Specifications

    Additional technical specifications, including 'Allowable Beam Loads', 'Allowable Column Loads', and 'Section Properties' can be found on the W150EH Channel w/Short Slots 12 Gauge 1-5/8" x 3-1/4" category page.

    Finish Finish Code Description
    Paint-Green Powder Coating GR A dark green low gloss powder coating is applied and thoroughly baked after steel has been cleaned and phosphatized.
    Features
    • Channels are manufactured by the cold roll forming process which produces cross sections of uniform dimensions within tolerances established by the Metal Framing Manufacturer's Association, Metal Framing Standards Publication No. MFMA-4.
    • Steel used in the manufacture of channels conforms to the ASTM specifications under the Specifications tab below.
    • Design is based on AISI S100-2016 "Specification for the Design of Cold-Formed Steel Structural Members." Maximum bending stress used in design is 25,000 pounds per square inch (PSI). This is based upon a virgin steel minimum yield stress of 33,000 psi cold worked to an average yield stress of 42,000 psi.
    • Welds meet the performance requirements of section 4 of AISI S100-2016 "Specification for the design of Cold-Formed Steel Structural Members." All multiple sections of two or more single channels are resistance spot-welded approximately 2" to 3" (51mm to 76mm) on center.
    W15OEHGR10


    For more information go to https://www.p65.warnings.ca.gov