Your Cart (0)
LITERATURE
CATALOG
SIGN IN
CART
Wesanco Branded/Strut/W150 - 1.625in X 3.25in 12ga Channel.pdf
W150EHPG20
W04
Thumbnail Filmstrip of 12 Gauge 1-5/8" X 3-1/4" 20' Channel, Short Slots, PG Images
Description
W150EHPG20, 12 gauge channel strut with short slots, 20 feet long, mill-galvanized (pre-galvanized).
- Strut: 1 5⁄8" (41mm) width x 3 1⁄4" (83mm) height
- Short Slots: 9⁄16" (14mm) x 1 1⁄8" (29mm) on 2" (51mm) centers
- Length tolerance plus or minus 1⁄16"
Technical Specifications
Additional technical specifications, including 'Allowable Beam Loads', 'Allowable Column Loads', and 'Section Properties' can be found on the W150EH Channel w/Short Slots 12 Gauge 1-5/8" x 3-1/4" category page.
| Finish | Finish Code | Description |
|---|---|---|
| Mill-Galvanized (Pre-Galvanized) | PG | Galvanized steel used in the manufacture of channel sections conforms to ASTM A 653 GR33 G90. Uncoated edges resulted from slitting, punching and channel cut off are present. |
Features
- Channels are manufactured by the cold roll forming process which produces cross sections of uniform dimensions within tolerances established by the Metal Framing Manufacturer's Association, Metal Framing Standards Publication No. MFMA-4.
- Steel used in the manufacture of channels conforms to the ASTM specifications under the Specifications tab below.
- Design is based on AISI S100-2016 "Specification for the Design of Cold-Formed Steel Structural Members." Maximum bending stress used in design is 25,000 pounds per square inch (PSI). This is based upon a virgin steel minimum yield stress of 33,000 psi cold worked to an average yield stress of 42,000 psi.
- Welds meet the performance requirements of section 4 of AISI S100-2016 "Specification for the design of Cold-Formed Steel Structural Members." All multiple sections of two or more single channels are resistance spot-welded approximately 2" to 3" (51mm to 76mm) on center.
W150EHPG20
W04
